Your Project Information will be displayed on submittal pages. You may pre-load it here, then when you
enter the submittal pages, the information will be inserted automatically. After you have entered all the data, be sure to Click Below to save the new settings.
Project:
Location:
Contractor:
Architect:
Engineer:
Rep. Information
Rep. Information will be displayed on submittal, drawing, and graph pages. You may pre-load it here, then when you
enter these pages, the information will be inserted automatically. After you have entered all the data, be sure to Click Below to save the new settings.
Name:
Address:
City State Zip:
Phone/Fax:
Email:
Selectable Units
Your current units are selected in the areas below. If you want to change one or all, simply find your desired unit in the appropriate box, and when all selections are made, click the button below to update the list
Volume
Static Pressure
Power
Velocity
Altitude
Density
Temperature
Tip Speed
Drawing Dimensions
Calculation Sensitivity
Calculation Sensitivity tells the program what percentage above or below the normal operating range of the fan is to be used in selections.
On a belt drive fan, this is the percentage of RPM below the minimum RPM, or the percentage of RPM above the maximum RPM.
For Direct Drive Fans, this percentage describes the operational band of the particular fan.
Solutions found are still within the published limits of the fan model, but within the percentage of the desired operational point.
Solutions made using this expanded zone are on the same system line as the desired Operational Point, and reflect the Actual Flow and Pressure
of the maximum or minimum RPM of the fan.